Christensen Tools, South Africa > Power Supplies & Scopes > Oryx Power Supplies

In the initial switch on the system will check and calibrate itself. IF all is found to be OK the two green lights under Sys and V will be lit. The output relay will then be energized and output voltage will be seen on the terminals.

Short circuit protection.

Power output over temperature protection. Should the outputs get too hot the unit will switch off output dc voltage until the temperature falls to within the operating temperature range. A red LED will light up under a thermometer symbol in this mode.

Voltage output over voltage sensing. Should a component fail in the output circuits this red LED under the V symbol will light up. The output voltage will be disconnected from the terminals in this mode.

Constant current mode available. A yellow LED will light up between the “Limit” and current symbols when this mode is invoked.

ONLY variable voltage will be shown on the digital screen on the left with the continuous output current on the right of the display.

Fixed voltage lines – ALL 1 amp current.

0 to +5v dc, 0 to -5v dc, 0 to -12v dc

Variable 0 to 30v dc up to 5amp.